Apple Logic Pro 7 User Manual download pdf (Page 674)

100

101

674 Chapter 22 Control Surface Support

Flip Group

When set (to any value other than “none”), this number defines a counterpart for Flip

Mode. By setting a fader and an encoder to the same Flip Group, for example, they are

coupled. To set “none”, enter 0.

Exclusive

Only for supported control surfaces: when the Exclusive checkbox is enabled, the

assignment deactivates all other assignments that have Exclusive disabled (for the same

control). This lets you limit the overwriting of a mode-less assignment to particular

modes.

Example: Faders normally control volume. If you want to have a mode where faders

control send level, enable Exclusive.

Class

This pop-up menu can be used to define the assignment class or, put another way,

what type of destination parameter is controlled. The following section explains all

available Class options.

Mode Change

The Mode Change option allows you to use an assignment to activate a mode in a

Zone. An additional Mode pop-up menu appears below the Class menu, offering

different Modes you can switch to. As an example: The Assignment buttons on a Logic

Control choose several Modes for the encoders.

Note: The Mode that is recalled also depends on the option set in the Value section’s

Mode menu (see the “Mode” section on page 680). The following table explains how

the different Value Modes take effect.

Value Mode option Explanation

Direct The stated Mode is activated in the Zone it belongs to. It is not necessary for

the Mode Change assignment to be located in the same Zone.

Example: While Shift is held down, button X switches the encoders to EQ view.

The Shift and X buttons are in Zone A, but the encoders are in Zone B.

All other value modes: Only the Modes of the Zone the Mode Change

assignment is located in can be recalled. The destination parameter minimum

is this Zone’s first Mode, and the maximum is the Zone’s last Mode.

Toggle A button might toggle between the Zone’s first Mode and the stated Mode

Relative Useful for stepping up and down through Modes of a Zone using two buttons,

or for choosing a mode using an encoder.

Rotate Useful for stepping through all modes using a single button. A jog wheel, for

example: Off → Scrub → Shuttle → Off

1 2 ... 669 670 671 672 673 674 675 676 677 678 679 ... 729 730

Comments to this Manuals

No comments

Apple Logic Pro 7 User Manual Page 674

Comments to this Manuals

Related products and manuals for Software Apple Logic Pro 7