Apple Logic Pro 7 User Manual Page 409

  • Download
  • Add to my manuals
  • Print
  • Page
    / 730
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 408
Chapter 11 Sample Editor 409
Parameters
Alongside Swing, you can set the percentage for the swing factor. At 50% there is no
change—you normally get the best results around 55% to 65%.
The Based On Period parameter determines whether the audio material should be
edited on the basis of eighth note, or sixteenth note swing, in the Groove Machine.
The Down Beat Level and Off Beat Level parameters determine whether the down beats
(or off beats) in the audio material should be raised or lowered. Positive values increase
the level, negative values reduce the level.
Bear in mind that raising the level of normalized audio material can cause distortions
(particularly on the down beats, which are usually louder).
The Corresponds to Tempo parameter automatically transfers Logic’s current tempo to
the Groove Machine.
The length or tempo of the selected audio material must be defined, or the Groove
Machine won’t work accurately. The length can be defined in musical values (bars,
beats, divisions, and ticks) via to Bar Length, or you can set the tempo directly by using
corresponds with Tempo.
Audio Energizer
The purpose of the Audio Energizer is to increase the perceived volume of audio
material, while altering the sound as little as possible, and without causing clipping.
Digital distortion (which would be the inevitable result of simply increasing the level,
and which sounds very unpleasant) is avoided by using this algorithm.
You could compare the effect to that of an analog tape which is saturated by a high
recording level. The distortion factor and effect on the audio material is much lower,
however.
Heres an example of the effect. If a normalized audio file (audio data which is already
at the maximum dynamic range) is edited, the effect is as follows: a VU meter will
show a higher level, indicating increased average energy in the signal. A peak display
will show the same level as before, as the maximum signal level has not been
exceeded.
Page view 408
1 2 ... 404 405 406 407 408 409 410 411 412 413 414 ... 729 730

Comments to this Manuals

No comments