Chapter 3 Preparing Clips in the Viewer
77
Learning About Motion Parameters
You’ve had a brief introduction to some of the changes you can make using the Viewer,
but many more are possible using the Motion tab.
By adjusting a clip’s motion settings, you can change its geometry to move, shrink,
enlarge, rotate, and distort in nearly any way you like. You can change any of these
options independently over time using keyframes, allowing you to create professional
eects and impressive changes to your clips.
As a general rule, you set keyframes in pairs, one at the beginning of a change
(as an anchor) and one at the end of the change (at which you specify a changed
parameter value).
Comments to this Manuals