95.08.23.09.17
Color LaserWriter 12/600 PS Take Apart 3–86
Mechanical Controller Mount and Board (page 2 of 3)
2 Remove the two silver-colored screws at the left and right side of the
board, and the one brass-colored screw below the board. Remove the
cables from the cable guide at the top of the board. Disconnect the
large connector going into J1004 on the high-voltage power supply.
Replacement Note: Make sure that you install the three screws tightly
in their correct locations.
12Cable Guide
3
Cable to J1004
Comments to this Manuals