26 Chapter 2 Installing or Replacing Components
Important: Save the blank drive module. Always keep a blank drive module in any
unused drive bay to maintain proper airow through the Xserve.
Remove the blank
drive module from the bay.
If there is a drive module already in the bay:
a Make sure the drive currently in the bay is not being used by any application or
being shared by the Xserve.
b Press the handle on the drive module so the handle pops out.
c Wait for the green, upper disk status light to go o. Then grasp the handle and
pull the drive module out of the bay. If the light doesn’t go out after 20 seconds,
an application probably has a le open on the drive.
Comments to this Manuals