To remove a SIMM, carefully spread the retaining clips at both ends of the
installed SIMM. Then rotate the SIMM upward until it can be pulled free of
the slot.
Yo u’ve now installed the expanded memory. You need only replace the side
cover to complete the installation.
Replacing the side cover
To replace the cover on the printer, follow these steps.
1Slide the cover’s top tab under the lip on the side of the printer.
2 Line up the tabs inside the side cover with the receiving slots on the printer.
3Gently place the side cover on the printer and slide forward.
Line up the tabs
with the receiving slots.
Slide top of cover under lip
before sliding cover forward.
WARNING
When installing a SIMM, avoid touching the printer’s circuit
board with hands or tools to avoid damaging or scratching the printed
circuits.
117
Installing Options
Comments to this Manuals