Apple Soundtrack Pro User Manual download pdf (Page 272)

272 Appendix A Using Apple Loops Utility

To move a transient marker:

m Drag the marker by its handle in the area above the Beat ruler.

To change the beat value of detected transients:

m Choose a beat value from the Transient Division pop-up menu.

Choosing a larger beat value results in fewer transients being detected. Choosing a

smaller beat value results in more transients being detected, if they are present in the

audio recorded in the file.

Sometimes transients occur at points in the audio file other than on a beat value. You

can have Apple Loops Utility detect additional transients in the file using the Sensitivity

slider. When you increase the sensitivity of transient detection, Apple Loops Utility

considers points of higher amplitude in the waveform as transients, regardless of

whether or not they occur at a beat value.

To change the sensitivity of transient detection:

m Drag the Sensitivity slider to the left to decrease the sensitivity, or to the right to

increase the sensitivity of transient detection.

To remove a transient, do one of the following:

m Click the transient’s handle in the area above the Beat ruler, then press the Delete key.

m Drag the transient out of the area above the Beat ruler.

1 2 ... 267 268 269 270 271 272 273 274 275 276 277 ... 310 311

No comments

Apple Soundtrack Pro User Manual Page 272