Apple Xserve RAID User's guide User's Guide download pdf (Page 50)

50 Chapter 6

2 Remove the blank drive module or the drive currently installed.

m If there is no drive installed, press the handle of the blank drive module so that it pops

out, then pull the blank drive module out of the front panel.

m If there is a drive module already in the bay:

a Make sure the drive currently in the bay is not part of a RAID set, or you could lose

data.

b Press the handle on the front of the drive module so that the handle pops out.

c Grasp the handle and pull the drive module out of its bay and set it aside.

3 Press to open the handle of the replacement drive module (if necessary) and slide it into the

empty bay until the module is ﬁrmly seated.

Press the handle on the blank drive

module until the handle pops out

and then pull the module out.

Security lock

Press the handle on the drive

module until the handle pops out

and then pull the module out.

Security lock

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 91 92

No comments

Apple Xserve RAID User's guide User's Guide Page 50