Apple Power Macintosh G3 Instruction Manual download pdf (Page 50)

50 Chapter 2

4 Carefully slide the drive carrier assembly backward until it is released from the ﬂoor of the

computer, then lift it out.

5 Assign a unique SCSI ID number to the device.

Check the instructions that came with the device for information on setting its ID number.

Some manufacturers have World Wide Web sites that provide information on conﬁguring

drives. You can also contact an Apple-authorized dealer, who may be able to install the drive

for a fee.

If your computer came with one Wide Ultra2 SCSI device, set the SCSI ID to any number but

0 or 7. If your computer came with two devices, use any SCSI ID number but 0, 1, and 7.

A single factory-installed drive uses SCSI ID 0; a second factory-installed drive uses SCSI ID 1;

and a third factory-installed drive uses SCSI ID 2. The SCSI PCI card has been assigned ID 7.

If you select one of these numbers for a new drive, the drive will not work properly.

Gently slide the entire drive carrier

assembly toward the rear of the computer

and lift it completely out. Be careful not

to crimp or abrade any wires that are

near or under the assembly.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 61 62

No comments

Apple Power Macintosh G3 Instruction Manual Page 50