Apple Power Macintosh G3 Instruction Manual download pdf (Page 51)

Working Inside the Computer 51

6 Screw the drive onto the carrier assembly with the drive’s connectors facing away from the

sheet metal side of the carrier.

Attach any new Wide Ultra2 SCSI drives to any open position on the carrier, then connect the

data ribbon cable to them.

The SCSI cable included with factory-installed SCSI drives has a built-in terminator block so

you don’t need to attach a terminator to the last device in the chain.

Some computers come with an Ultra ATA drive in drive carrier position 3.

Screw the drive into

position with the four

screws supplied with it.

Follow the instructions that came with your third-party SCSI card to determine

what type of SCSI ribbon cable to use and how to connect it to this connector.

ATA hard disk drive

Position the hard disk drive on

the drive carrier so that the ribbon

cable connector and the power

cord connector are accessible.

SCSI hard disk drive

Drive position 1

will also accommodate

a SCSI hard disk drive.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 61 62

No comments

Apple Power Macintosh G3 Instruction Manual Page 51