Apple iMac G3 (Original) User Manual download pdf (Page 23)

m AT&P1 (33/66 pulse dial make/break ratio)

m ATS0 = 0 or ATS0 = 1 (no answer or answer greater than one ring)

m ATS6 = 95 (DTMF period between 70–255 ms)

m ATS11 = 95 (DTMF period between 70–255 ms)

For calls that are automatically generated, a total of three call attempts are allowed to a telephone number, with a

minimum period between calls of 2 seconds. If the call does not connect after three attempts, 30 minutes must

expire before automatic redialing may be initiated. Failure to set the modem (and any associated communications

software) to the above settings may result in the modem being non-compliant with Australian telecommunications

standards. Under these circumstances a user could be subject to signiﬁcant penalties under the

Te lecommunications Act 1997.

Information You Need in New Zealand

This modem is fully approved to operate on the New Zealand telecommunications network under Telepermit

number PTC 211/98/119. All telecommunications devices are required to hold a Telepermit and be labelled

accordingly with the approved Telepermit number to comply with the New Zealand telecommunications standards,

ensuring the health and safety of the operator and the integrity of the New Zealand telecommunications network.

Note: Customers in New Zealand who are prompted to choose a country for their modem should choose the

“Australia” country code setting.

To ensure compliance, all calls that are automatically generated should not make more than 10 call attempts to the

same number within any 30 minute period with a minimum period between calls of 30 seconds. Failure to adhere to

these standards may result in the modem being non-compliant with New Zealand Telecom standards. Under these

circumstances a user could be subject to signiﬁcant penalties.

Important If pulse dialing is required for any reason, the communications software must be set up to record

numbers according to the following translation list.

m Number to be dialed: 0; number to be entered into computer: 0

m Number to be dialed: 1; number to be entered into computer: 9

m Number to be dialed: 2; number to be entered into computer: 8

m Number to be dialed: 3; number to be entered into computer: 7

m Number to be dialed: 4; number to be entered into computer: 6

m Number to be dialed: 5; number to be entered into computer: 5

m Number to be dialed: 6; number to be entered into computer: 4

m Number to be dialed: 7; number to be entered into computer: 3

m Number to be dialed: 8; number to be entered into computer: 2

m Number to be dialed: 9; number to be entered into computer: 1

m Number to be dialed: 0; number to be entered into computer: 0

The preferred method of dialing is to use DTMF tones as this is faster than pulse (decadic) dialing and is readily

available on almost all New Zealand telephone exchanges.

Mouse Information

This product complies with the requirements of European Directives 72/23/EEC and 89/336/EEC.

Complies with the Canadian ICES-003 Class B Speciﬁcation.

Warning This card must be properly secured in order for you to use it. Telecommunications network voltages

exist inside the computer and the telecommunications line connection must be removed before opening the

computer.

1 2 ... 18 19 20 21 22 23 24

No comments

Apple iMac G3 (Original) User Manual Page 23