14 Chapter 1 Getting Started
To connect to a DSL or cable modem or an Ethernet network:
m Connect the cable to your DSL or cable modem as shown in the modem instructions,
or connect the Ethernet cord to the Ethernet hub or outlet. Then connect the other
end of the cord to the computer’s Ethernet port.
Step 4: Turn On Your PowerBook
With your setup information gathered, you’re ready to start up your computer. Once
you do, Setup Assistant opens automatically to help you.
1 To turn on the computer, press the Power button (®).
Note: When you press the Power button to start up your computer, press it only once
briefly (up to 1 second). Do not continue to hold down or press the Power button after
the startup tone or you may cause the computer to shut down again.
Ethernet cord
®
G
Ethernet port
(10/100Base-T)
®
® Power button
LL3093.book Page 14 Friday, February 4, 2005 5:50 PM
Comments to this Manuals