Apple Xserve (Early 2008) DIY Procedure for Hard Drive User Manual download pdf

 Xserve

073-1178 Rev. A

Hard Drive

Replacement Instructions

Follow the instructions in this document carefully. Failure to follow these instructions could

damage your equipment and void its warranty.

Online instructions are available at http://www.apple.com/support/diy/.

Note: These instructions apply to the hard drive of various Xserve models. Your server may look

slightly dierent than the one shown in the images.

Note: Blank drive carriers, which may ll some of the hard drive bays, follow the same

replacement procedure as hard drives. If you are replacing a blank carrier with a drive module,

be sure to keep the blank for possible future use. Blank drive carriers must be installed in all

empty drive bays to maintain proper airow through the server. Be careful not to apply excessive

pressure when installing the blank carriers.

Backing Up Your Data

Warning: Before replacing your hard drive, make sure you back up all data on the drive.

Tools Required

No tools are required for this procedure.

Preliminary Steps

The server includes three drive bays for the Apple Drive Modules. The modules consist of hard

drives attached to carriers; they are removed from or installed in the server as a unit. You can

replace hard drives while the system is running; you do not need to shut down or open the

server rst.

Note: There are two LED indicators on the front of each drive.

The upper LED shows drive status—a green light indicates the drive is good; a yellow or red •

light indicates the drive should be replaced or removed and reinserted.

The lower LED shows drive activity—when the light is blinking, the server is reading from •

1 2 3

Summary of Contents

Page 1 - Hard Drive

 Xserve 073-1178 Rev. AHard DriveReplacement InstructionsFollow the instructions in this document carefully. Failure to follow these instructions cou

Page 2

Xserve Hard Drive Replacement Instructions 2or writing to the drive. To avoid losing data, never remove a drive when the lower LED is blinking.If the

Page 3 - Formatting the Hard Drive

Xserve Hard Drive Replacement Instructions 3Installing the Replacement Hard DrivePress the handle on the front of the replacement drive module so tha

Comments to this Manuals

No comments

Apple Xserve (Early 2008) DIY Procedure for Hard Drive User Manual

Browse online or download User Manual for Software Apple Xserve (Early 2008) DIY Procedure for Hard Drive. Apple Xserve (Early 2008) DIY Procedure for Hard Drive User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Software Apple Xserve (Early 2008) DIY Procedure for Hard Drive