KApple Ethernet CS Thin Coax Card User’s Guide
62. Open the Installer program, review theWelcome screen, and click OK. 3. Make sure that the disk indicated on theInstaller’s dialog box is your cu
Setting the Network control panel for EtherTalkA Macintosh computer’s network connection is preset forLocalTalk. To connect to an Ethernet network ins
85. If you see the following dialog box, click OK.If you don’t see a dialog box, skip to step 6.If your network has been set up to allow you to choos
9TroubleshootingFollowing are guidelines for handling common problems. Ifthese suggestions don’t help you fix the problem, contactyour network adminis
If you don’t see network services listed in the Chooser: Make sure your network connection is okay. Open theNetwork control panel and click EtherTalk.
11SpecificationsConnector Ethernet IEEE 802.3–compliant BNC portCable RG-58/U; 2-meter minimumlength between devicesTerminator 50 Ohm, BNC-type Ethern
030-5460-B
FCC statementThe equipment described in this manual generates and usesradio-frequency energy. If it is not installed and used properly—that is, in str
DOC statementDOC Class B ComplianceThis digital apparatus does not exceed the Class B limits forradio noise emissions from digital apparatus set out i
About this communications cardThe Apple Ethernet CS Thin Coax Card expands thecommunications capabilities of models of Macintoshcomputers that have a
2Installing and connecting your card1. Follow the specific setup information thatcame with your Macintosh to open the backpanel or lid, and locate the
35. Follow the directions that came with yourcomputer and replace the back panel or lid,and reattach any cables you removed earlier. Depending on the
8. Lock the free end of the new cable to the T-connector on the other computer.9. If you are adding your computer somewhere inthe middle of the networ
5Installing EtherTalk software To install the correct version of EtherTalk software you need to use the Installer program on the NetworkSoftware Insta
Comments to this Manuals