Apple Xserve G5 User Manual download pdf (Page 48)

48 Chapter 3 Installing Your Server in a Rack

3 Just beyond the rear post of the rack, position the short-rack bracket beside the cover

so that the small pin on the bracket fits into the oblong hole closest to the post.

The small pin on the bracket faces inward, toward the cover, and it is near the top of

the bracket. The L-shaped flange at one end of the bracket faces away from the cover

and is close to the rack’s rear post.

Note: One of the short-rack brackets is designed for the left side of the cover and the

other fits the right side. Be sure to use the correct bracket on each side.

4 Insert one short screw through the top hole in the bracket and use it to fasten the

bracket to the cover. Do not tighten the screw all the way.

Be sure that you can still move the bracket back and forth.

Insert the pin on the short-rack bracket into one of the oblong

holes in the cover. There are two places to attach the short-rac

bracket; use the one that best fits your rack.

Each short-rack bracket is designed to be used on only one side of the cover.

Orient the right short-rack bracket (as viewed from the front of the system) as shown.

The left short-rack bracket is inserted on the other side of the cover.

Insert one short screw through the top hole in each short-rack bracket and tighten the bracket snugly

against the top cover. Do not tighten the screws completely—leave them loose enough so that you

can adjust the short-rack bracket slightly if you need to. You’ll tighten these screws completely later.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 95 96

No comments

Apple Xserve G5 User Manual Page 48