Apple iMac G5 Power Supply, 20-inch User Manual

033-2497 Rev. B  iMac G5 Power Supply, 20-inch Replacement Instructions Follow the instructions in this document carefully. Failure to follow thes

10 - iMac G5 Power Supply, 20-inch Installing the Replacement Power Supply 1. Remove the replacement power supply from its packaging. Replacement

iMac G5 Power Supply, 20-inch - 11 3. When the power supply is installed properly it should be flush with the gray plastic parts on the right and lef

12 - iMac G5 Power Supply, 20-inch5. Connect the ambient light sensor cable to the connector on the logic board (if your computer model has one). I

iMac G5 Power Supply, 20-inch - 13 7. Tighten the two captive screws and replace the screw on the right.

14 - iMac G5 Power Supply, 20-inch Closing the Computer 1. Replace the cover so that the slots on the top edge of the cover mate with the tabs on t

iMac G5 Power Supply, 20-inch - 15 3. Tighten the case screws by turning them clockwise. You might need to tighten the middle screw first, then adjus

16 - iMac G5 Power Supply, 20-inch  Apple Computer, Inc. © 2005 Apple Computer, Inc. All rights reserved.This document is protected under U.S. C

2 - iMac G5 Power Supply, 20-inch Important Things to Know 1. The replacement power supply has an ambient light sensor attached with two plastic ri

iMac G5 Power Supply, 20-inch - 3 Opening the Computer Note: These instructions cover the iMac G5 (20-inch) models. The models may look slightly

4 - iMac G5 Power Supply, 20-inch4. Locate the three case screws circled below. Lift the metal foot to locate the middle case screw. Note: These

iMac G5 Power Supply, 20-inch - 5 Removing the Power Supply 1. Ground yourself. Touch the metal surface (as shown below) on the inside of the comput

6 - iMac G5 Power Supply, 20-inch2. Locate the power supply shown in the picture below.3. Remove the screw on the far right and loosen the other tw

iMac G5 Power Supply, 20-inch - 7 4. Disconnect the power supply cable by pressing the connector release tab and using a wide, flat blade screwdriver

8 - iMac G5 Power Supply, 20-inch6. Proceed to the next step if you do not have and ambient light sensor. For more information, refer to “Important

iMac G5 Power Supply, 20-inch - 9 8. Grab the power supply by the sides and tilt the power supply toward you until it clears the edge of the main ci