LED Cinema Display (24-inch) Symptom Charts — Display Issues 25
2010-02-08
Verify display’s USB hub and 2.
built-in camera are listed
in the System Proler’s USB
device tree is not disappearing
intermittently (refresh System
Proler to observe).
Yes Power supply OK.
Go to step 3.
No
Go to Dead Unit/No Power
symptom code ow.
Unplug and replug the 3.
Mini DisplayPort and USB
connectors into a supported
powered-up portable system
and monitor the portable’s
display. Verify that the
portable’s display briey turns
o then back on.
Yes If connections are secure and
display still shows unstable
ickering, go to step 4.
No Reseat connectors and retest.
Verify all connections between 4.
power supply, all-in-one cable,
LCD, and logic board are secure.
See Functional Overview.
Yes If connections are secure and
the display is still unstable
ickering, go to step 5.
No Reseat connectors and retest.
Disconnect all-in-one cable 5.
and LCD function interface
cable from logic board and
system. Verify connectors and
cable under magnication for
pinched cables and damaged/
bent pins.
Yes
If cable is damaged,
replace all-in-one cable or
replace LCD function
interface cable.
L14
No Go to step 6.
Disconnect LED driver cable 6.
from logic board. Verify
connectors and cable under
magnication for pinched cable
and damaged or bent pins.
Yes
Damaged LED driver cable.
Replace LCD panel.
L14
No Go to step 7.
Shine bright (low heat) 7.
ashlight into the front of the
LCD. Verify if an image is being
displayed during ickering.
Yes
Image present but backlight
is ickering.
Replace logic board.
L06
No
Replace LCD panel. L06
Verify the source of the noise 8.
is the electrical as opposed to
mechanical
Yes Noises that are not audible
from the normal user position
are considered acceptable.
No
Noise from another source.
Go to Noise, Hum, Vibration
symptom code ow.
Comments to this Manuals