073-0841 Rev. A Power Mac G4 Cube Optical Drive Replacement Instructions Follow the instructions in this sheet carefully. Failure to follow thes
Power Mac G4 Cube Optical Drive - 10 2. Install the connector board on the replacement optical drive, and secure it to the drive with the two screws
Power Mac G4 Cube Optical Drive - 11 5. Install the screws, but do not tighten until all four are in place. Do not overtighten.6. Close the AirPort
Power Mac G4 Cube Optical Drive - 12 Replacing the Top Plate Assembly 1. With the top plate assembly in hand, connect the cable from the top plate t
Power Mac G4 Cube Optical Drive - 13 2. Install the LED cover over the power button LED on the top plate assembly.3. Position the top plate assembly
Power Mac G4 Cube Optical Drive - 14 Replacing the Computer Core in the Enclosure 1. Make sure that the power button gasket is secured inside the re
Power Mac G4 Cube Optical Drive - 15 2 Holding the core by the latch, insert the core into the enclosure. (Figure 20)Note: The core fits into the
Power Mac G4 Cube Optical Drive - 16 4 Turn your computer upright and reconnect all cables.5 Restart your computer. Warning: Never turn on your com
Power Mac G4 Cube Optical Drive - 2 Removing the Computer Core From the Enclosure Warning: Always shut down your computer before opening it to avoid
Power Mac G4 Cube Optical Drive - 3 6 Turn the computer upside down, and push down on the latch to release it. Allow the latch to extend completely.
Power Mac G4 Cube Optical Drive - 4 Removing the Top Plate Assembly 1. Press the latch in, and turn over the core so the power button faces up.2. Re
Power Mac G4 Cube Optical Drive - 5 4. Lift out the LED cover that is fitted over the power button LED. Set the LED cover aside for installation on t
Power Mac G4 Cube Optical Drive - 6 Removing the Installed Optical Drive Note: The procedure is the same whether the optical drive is a CD-RW or
Power Mac G4 Cube Optical Drive - 7 3. Using a magnetized screwdriver, remove the two screws from the side of the drive. Repeat on the other side.
Power Mac G4 Cube Optical Drive - 8 4. Warning: If the optical drive case is squeezed too tightly, the laser lens could be damaged. When handling
Power Mac G4 Cube Optical Drive - 9 6. Disconnect the board from the drive by removing the two screws. Then pull the board off of the drive. (Figur
Comments to this Manuals