Apple A1260 User Manual

MacBook Pro 15" Core 2 Duo ModelsA1226 and A1260 SSD Dual DriveInstallationWritten By: iRobotINTRODUCTIONThere are many benefits to adding a seco

Step 16 For 7 mm SSDs, you'll need to apply a spacer to ensure a good fit.Peel the backings up off the adhesive strips mounted on the spacer.Pr

Step 18 Once the hard drive is snug, reinsert the plastic positioner while holding the hard driveagainst the bottom of the enclosure.Reconnect any cab

To reassemble your device, follow these instructions in reverse order.This document was last generated on 2013-08-24 08:00:36 AM.Step 20Attach the opt

Step 1 — Battery Use your fingers to push both battery release tabs away from the battery, and lift thebattery out of the computer.Step 2 — RAM Shield

Step 3 — Upper CaseRemove the two 2.8 mm Phillipsscrews in the battery compartmentnear the latch.Step 4Remove the following 6 screws:Two 10 mm T6 Torx

Step 5Remove the four 3.2 mm Phillipsscrews on the port side of thecomputer.Step 6Rotate the computer 90 degreesand remove the two 3.2 mmPhillips scre

Step 7Rotate the computer 90 degreesagain and remove the four 3.2 mmPhillips screws from the side of thecomputer.Step 8 Do not yank the upper case o

Step 9 Disconnect the trackpad and keyboard ribbon cable from the logic board, removing tape asnecessary.Note: It is possible to replace the hard driv

Step 10 — Optical DriveUse the flat end of a spudger todisconnect the orange SuperDriveribbon cable from the logic board,removing tape as necessary.St

Step 12 — Optical Drive Replacement If your new optical drive already has brackets on it, you'll only need to transfer thedata cable to your new

Step 14Rotate the drive and remove thetwo Phillips screws securing themounting bracket to the right sideof the optical drive.If you purchased an optic